CALL US TOLL FREE | 9am-6pm EST | M-F
LOCATIONS ACROSS THE NATION | TO SERVE THE ENTIRE COUNTRY
Leading Automotive Equipment Dealer Since 1987
CALL US TOLL FREE | 9am-6pm EST | M-F
LOCATIONS ACROSS THE NATION | TO SERVE THE ENTIRE COUNTRY
Leading Automotive Equipment Dealer Since 1987
Atlas® Platinum XH-PRO9-Combo1
Extra Tall - Extra Wide Lift
To View Atlas 4 Post Cylinder Bleeding Procedure Click Here
(Do this immediately after installation)
This Atlas® Garage Pro 9000 4 post lift can accommodate a 187" vehicle. The Atlas® Garage Pro 9000 has the longest runways (we believe) of any portable 9,000 LB. four post on the market. The Atlas® Garage Pro 9000 weighs about 300 LB. more than our Atlas® Garage Pro 8000. The Atlas® Garage Pro 9000 four post above ground lift incorporates many features that are not found in any of our competitors' four post lifts that are sold in the USA. This lift is a portable four post lift incorporating polyurethane casters on the caster kit to prevent damage to the garage floor.
The Garage Pro 9000 can lift your pick-up truck or car up to 85 inches in the air. This above ground lift is the perfect choice for parking taller vehicles under your stored vehicle. The commercial grade features of the Garage Pro 9000 make this lift the perfect choice for automotive service center or Mr. Homeowner that needs a PORTABLE professional four post lift at a competitive price.
Supersedes RJ35
The Atlas® PROJACK35 (RJ35) 3500 lbs. capacity sliding hydraulic bridge jack is the perfect choice for the owner of the Atlas® Garage PRO8000 or any of our other Atlas® Garage Pro lifts. The PROJACK35 Sliding Jack will also work on our other hobbyist four post lifts such as the ALI Certified Atlas® APEX8 and APEX9 as well as the Premium Atlas® 408SL and 409HP. The PROJACK35 Sliding Jack is perfect for those who want to perform wheel service on a vehicle that is positioned on top of their four post lift..
Most four post hobbyist lifts come with a jack tray. The jack tray has certain limitations that are eliminated by using the Atlas® PROJACK35 Sliding Jack. The jack tray (with a small floor jack or jack stands) will support ONLY THOSE LIFTING POINTS of the raised vehicle that are between the runways of the four post lift. The RJ35 Sliding Jack has telescoping arms that can be extended over the runways of the four post lift. The lift pads at the end of these arms can be positioned under the LIFTING POINTS (that are located over the runways of the four post lift) of the vehicle allowing the operator to access many more LIFTING POINTS than just using the jack tray.
The Atlas® PROJACK35 Sliding Jack comes standard with a set of peg style truck adapters which increase the lifting height of the lift pads. These truck adapters will allow the Atlas® PROJACK35 Sliding Jack sliding hydraulic jack to raise pick up trucks that will sit higher on the runways than the average passenger car. The Atlas® RJ-35 Sliding Jack is operated by a manual hydraulic pump (porta-power pump) and does not require an air compressor for power. The Atlas® PROJACK35 Sliding Jack sliding hydraulic jack also features two solid locking positions that are used when the vehicle is to be suspended above the runways. When the locking positions of the Atlas® RJ-35 Sliding Jack are engaged, the hydraulic pressure from the lifting cylinder of the RJ-35 Sliding Jack is eliminated. (These locks act much like a pair of jack stands after you lift a vehicle off the ground with a service jack).
Finally, the versatile Atlas® PROJACK35 Sliding Jack is adjustable to fit between the runways of many of the other four post lifts that have been sold in the last several years.
