MorrHeat MH320 Waste Oil Heater 320,000 BTU

The MH320 320,000 BTU Waste Oil Heater is the ideal unit for 6-8 bay garages and commercial shops. Capable of heating up-to 8000 sq. ft. while consuming less than 2 GPH., it doesn't take much fuel to heat the desired area. This unit features a triple pass system designed with two stainless steel heat ex-changers, hinged swing out doors on both sides of the waste oil heater for easy ash removal, burns heating fuels, diesel fuels and used-waste motor oils.

Comes standard with the waste oil burner, on-board air compressor so you don't have to use shop air, fuel pump assembly, room thermostat and draft meter. With the MorrHeat line of waste oil heaters you save on hauling fees associated with waste oil removal, lower your heating bill and overhead through the winter months and increase profits at the same time.

• Perfect heating unit for 6-8 bay garages and commercial shops
• This small but efficient waste oil heating unit heats up to 8,000 square feet and has an out-put of 275,000 BTU’s
• Only consuming 2 gallon per our when operating, not much used oil is needed to keep the desired area warm while offering fast recovery times when opening and closing bay doors
• Easy access to the fire chamber and heat exchangers make it very quick when cleaning or maintaining the MH320 waste oil heater
• The combination of the MorrHeat waste oil burner and fuel pump assembly make for a very easy install and doesn’t limit the location of the heater according to where the fuel storage tank is in the building
• When hanging the waste oil heater there are four all thread bolts conveniently located on the top of the heating unit for easy ceiling mounting
• Burner Assembly - Shop Air System
• Regulated Fuel Pump with Fuel Regulator
• Fuel Types: Intended for operation with oil not heavier than ASTM D396 No. 2, used crankcase oil, used automatic transmission fluid (ATF), and used hydraulic fluid.

This Item Does Not Contain Any CA Prop 65 Listed Chemicals